GEARED SHAFT - UNISAW FENCE REPLACEMENT PART for the MICRO ADJUSTER - ALL NEW

Description

ALL NEW - NOT AN ORIGINAL USED DELTA FENCE SHAFT
Replacement pinion shaft with the small gear on end to allow for micro adjustment of your Unisaw fence.
Fits all vintage Delta Unisaws with the rack gear cut into the bottom side of the front fence rail.
This is an "all new" machined shaft.  It is an exact reproduction of the obsolete delta Unisaw part number 422-04-351-5002.  It will replace a missing Micro-set shaft, or replace any of those with broken or missing teeth at the gear..
This component is are often found to be missing or damaged during a rebuild of a vintage Unisaw.  Our geared shafts are now black oxided plated for increased corrosion protection.  The oxide plated shafts are shown in one of the photos.
The price listed is for one shaft.  The knobs shown in the photos are for reference only and
are not included
with the shaft purchased from this site.
The shaft is designed for a light press-fit into the knob.  However, each shaft order from this site is provided with a small vial of Loctite retaining compound, should you find that your existing old knob fits too loosely on the new shaft.
We do have new billet aluminum style knobs available as shown in the photos.  We also have a matching "finger" knob available for the early style Unisaw fence.  Please check these out on another of our Unisaw parts sites on eBay.
A few stock diecast knobs are also shown in the photos.  Although limited in quantity, these are also available for purchase upon request.
Shipping is .00 to anywhere in the lower 48 states.
Shipping to other locations will be calculated based on zip code and quoted before payment is accepted..
Payment by PayPal is preferred.