Thorens TD-160 145 147 160 MKII 145 MKII Replacement Spring Kit for Turntable

Description

Be wary of other spring kits using "nirvana" in the eBay product title; those springs are Linn springs, very different in specs from these US-made springs reverse-engineered from the originals.
Thorens TD-160 TD-145 TD-TD-160 MKII, TD-145 MKII, TD-150 MKi and MKii, TD-160 Super Replacement Spring Kit for Turntable
Replace your tired springs.  Includes three fresh springs engineered to match the original Thorens springs, as well as three grommets, six metal washers, three plastic washers, and three thread-lock nuts.
At last, after decades without true Thorens replacement springs, I have had new springs manufactured by one of the most respected spring-makers in the US.  These high quality springs were reverse engineered from original Thorens springs...these are not Linn LP-12 springs in disguise!  (LP12 springs, by the way, have completely different specs in every key facet of the design)
Obviously, the heart of the suspended subchassis turntable design is the springs.  They isolate the subchassis in a frequency range that optimizes resonance control.  If you have never taken a look at your existing springs and grommets, they more than likely resemble the springs and grommets in the last several photos: worn, rusted, misshapen.
Note how the old spring tilts to one side.
If your tired springs are not doing the job they were designed to do, the performance of the entire turntable suffers.
This new kit not only contains three fresh springs, it contains:
Three rubber grommets in a taller design to help increase spring stability in the horizontal plane
Six metal (316 stainless steel) washers and three plastic washers, the configuration Thorens used in the TD-160
Super
model. The plastic washer prevents binding as it slides between the metal ones.
Three Type 316 Stainless Steel, Nylon-insert Locknuts to prevent slippage once your table's suspension is properly tuned
As with my other kits and manufactured parts, I have tried to meet or exceed the original product. In this kit that is represented by 1) using non-magnetic, non-rusting 316 stainless steel nuts and washers 2) using a locknut instead of  a regular nut being held in place by blue paint 3) expanding height of the top grommet which helps immediately with stability in the horizontal plane, and 4) copying the TD-160 Super metal/plastic washer "sandwich" design which prevents binding and allows "turning" the springs even once seated.
Please note the turntable stud in a couple of the photos is NOT included. You use the existing studs and the existing lower grommets. You can also choose to reuse the existing foam inserts or install without them. (As of April 2020, I have been unable to source new foam inserts, sorry.)
Please note these springs are only for the models listed at the top. See separate listings for TD165/166/146/166 MKii and TD125 models.
I've created three youtube videos showing exactly how to remove your old springs/grommets/washers/nuts and install the new kit. The first two videos are available for all to see, but the third video, showing adjustment/tuning of the suspension, will only be visible to those purchasing the kit.  Those who have purchased the kit should email me once you receive it to the email address on the enclosed business card.
Be wary of other spring kits using "nirvana" in the eBay product title; those springs are Linn springs, very different in specs from these US-made springs reverse-engineered from the originals.